Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LAN-to-LAN VPN

Hi,

I currently have a PIX setup at SiteA and a 1720 router at SiteB. There is a LAN-to-LAN tunnel between the 2 sites. If I was to setup a second tunnel at SiteB terminating on the 1720 router, will it be possible to configure the tunnels so SiteA also has access to the customer VPN tunnel?

I would also want to have VPN tunnels that terminate at the PIX (SiteA) to also be accessible from SiteB.

Would it just be a case of configuring the crypto ACL's for the traffic?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions

Re: LAN-to-LAN VPN

have a look at the following link will be very usefull

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00807f9a89.shtml

good luck

if helpful Rate

3 REPLIES

Re: LAN-to-LAN VPN

have a look at the following link will be very usefull

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00807f9a89.shtml

good luck

if helpful Rate

New Member

Re: LAN-to-LAN VPN

I think that helps. From my understanding of it, for the customer VPN tunnels that terminate on the 1720 and that need to be accessed from behind the PIX, I should only need to modify the crypto map acl's and the NAT0 acl's. The same interface traffic issue doesn't apply in this case. Is this correct?

Re: LAN-to-LAN VPN

correct, the 1720 won't have a problem with same interface traffic.

170
Views
5
Helpful
3
Replies