Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Linksys WRVS4400N IPSEC to Cisco Con. 3030

I am trying this connection from the 4400N, but I never even see phase 1 try and connect through my FW. Running latest firmware on 4400N. Anyone have experience with these? Seems strange the 4400N isn't even attempting out. Using Comcast connection with a dummy bridged modem.

1 REPLY
Silver

Re: Linksys WRVS4400N IPSEC to Cisco Con. 3030

Go to Configuration >> system >> events >> classes and add in auth, authdbg, IKE, IKEDBG, IPSEC, and IPSECDBG. Then go to Monitoring >> filterable event log and clear the log. At this point disconnect all instances of a connection to the linksys that is having a problem and wait for it to reconnect. Once reconnected, check to see if there are multiple instances. If yes, then check again the Linksys router's configuration.

238
Views
0
Helpful
1
Replies
CreatePlease to create content