Does anyone knows how can I configure an L2TPoIPSec Microsoft client in order to identify itself with an FQDN (Fully Qualified Domain Name)? The resaon wky I need this configuration is because I am establishing the IPSec tunnel with an 7200 (configured as IPSec concentrator), and the 7200 it's configured with VRF aware IPsec. This way I need to match the FQDN to associate the client with a certain VRF (the client have dynamic IP address, this way I cannot use the IP address to make the association with the VRF).
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...