I am in the process of setting up a multi site VPN, the first tunnel (VPN1) is up and running fine. It was when I went to do the second tunnel that I encountered issues. I believe I resolved them, and that the problem was I had an ACL that was reversed. With our local network being 10.10.6.0/24 I had "....extended permit ip10.150.0.0 255.255.128.0 10.10.6.0 255.255.255.0". 10.150.0.0/17 was the remote network, that I had reversed in the ACL, which is a network that does not exist locally. So, then this explained why there was no outbound traffic coming from our network. Before I schedule the next time we set these up I would like to insure I have this down right. Below is the current config. I don't believe there is anything else I need to do to differentiate the seperate VPNs. Each tunnel should have a unique ACL that matches the crypto map, then that network should be included in the same "no nat ACL".
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...