Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAT,ASA, 2 neworks and a VPN tunnel

Hi. I have a following question. I'm trying to establish a VPN tunnel to a remote network that used to be connected to ours over a VPN tunnel. The problem is the previous tunnel from their side was established to the x.x.x.x network on our side which will not be used anymore in about a month's time but is currently still active and used. As I'm trying to get this VPN tunnel up as soon as possible without going through all the red tape on the other side(politics, don't ask) is it possible to do NAT of the new network into the x.x.x.x network for traffic going over the VPN tunnel.

Something like this:

new network->policy NAT into old x.x.x.x range on ASA->VPN tunnel to remote network using x.x.x.x addresses

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: NAT,ASA, 2 neworks and a VPN tunnel

It is possible to add the new policy but sometimes it can conflict with the old one.

1 REPLY
Bronze

Re: NAT,ASA, 2 neworks and a VPN tunnel

It is possible to add the new policy but sometimes it can conflict with the old one.

111
Views
0
Helpful
1
Replies