Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

NAT for VPN dialin users

I've just set up dialin VPN on my PIX 515e.  The users can connect fine but

a) my split tunnel ACL is not applied and

b) I have the following error in syslog No translation group found for udp src outside:10.0.56.2/137 dst inside_lan:10.0.8.6/137

If i try to ping my inside interface from the client, i get a reply from the outside interface IP address.

Do I need a specific NAT rule for my VPN client users?

2 REPLIES

NAT for VPN dialin users

Not sure which IP is from VPN Pool but you should have no nat configured between VPN POOL and Inside Subnets.

Thanks

Ajay

New Member

NAT for VPN dialin users

This is correct and indeed how it was already configured.

The problem was I wasn't excluding my return traffic from NAT.

324
Views
0
Helpful
2
Replies