Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

NAT on VPN IP Pool

Hi,

Would just like to ask if it's possible to NAT the ip pool of VPN remote-access users to the router's outside IP address? The router is a Cisco1841.

Thanks!

1 ACCEPTED SOLUTION

Accepted Solutions

Re: NAT on VPN IP Pool

Patricia,

Are you refering to PATing your RA IP pool using your outside interface just as you do with your LAN subnets in ip nat overload?, if so this link depicts similar example using route map, PLS let us know if this is not what you are looking for and if you could perhaps elaborate as to what is it that you are trying to accomplish.

http://www.cisco.com/en/US/products/sw/secursw/ps2308/products_configuration_example09186a008073b06b.shtml

Regards

2 REPLIES

Re: NAT on VPN IP Pool

Patricia,

Are you refering to PATing your RA IP pool using your outside interface just as you do with your LAN subnets in ip nat overload?, if so this link depicts similar example using route map, PLS let us know if this is not what you are looking for and if you could perhaps elaborate as to what is it that you are trying to accomplish.

http://www.cisco.com/en/US/products/sw/secursw/ps2308/products_configuration_example09186a008073b06b.shtml

Regards

Community Member

Re: NAT on VPN IP Pool

Hi,

Your understanding to my problem is right.  I'll try to test the sample config from the link you've posted.  The main issue is that we wanted to access a group of servers outside our network while connected to the VPN.  Unfortunately, putting up an L2L VPN in between is out of the question.  We need to translate the RA IP pool to the outside interface as this IP address has access to the remote servers.  If you have links that would best describe this problem, that would be wonderful.

Thanks,

Patricia

183
Views
0
Helpful
2
Replies
CreatePlease to create content