NAT-Traversal command not staying after ASA restart

[deyster94]

I have noticed that when I restart an ASA that has nat traversal enabled, the command is disabled (it goes back to no crypto isakmp nat-traversal). No matter what I try, it doesn't seem to stick. Any ideas/solutions?

Thanks.

Dan

[Ivan Martinon]

There is a software problem on the ASA (bug) that causes this, you need to get your ASA to the latest version available.

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCsj52581

I would say go to version 8.0.4