Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

No address available for SVC connection!

I am trying to create a SSLVPN connection using Cisco Anyconnect Client after entering username and password, I am getting following error message in attached screenshot. I already created a ip local pool vpnpool 192.168.60.10-192.168.60.15 mask 255.255.255.0 and associated with correct tunnel-group sslgroup. Everytime i attempt to connect i get error message no address available for SVC Connection.

Any help or suggestions related to this issue will be helpful.

Thanks,

Ali

3 REPLIES
New Member

No address available for SVC connection!

HI Ali,

This error message sometimes will show if you have another connection to the ASA from same subnet OR you have RDP session open.

Plz rate if this helpful.

Regards,

MKD

New Member

Re: No address available for SVC connection!

Hi MKD,

I only have one telnet session open and ASDM session to this ASA on top of that I am using CiscoAnyConnect to intiate SSL Connection. I also try to close ASDM session and reattempted again but getting same error message.

Do you have any other suggestions?

Forgot to mention I don't have a RDP session opened.

Thanks,

Ali

New Member

Re: No address available for SVC connection!

Hi Ali,

Try to make all the selection not as (inherit), select the pool manually for that policy.

And change user login.

Plz check the attached screen shot.

Plz rate if this helpful.

Regards,

MKD

10536
Views
5
Helpful
3
Replies
CreatePlease to create content