No Intranet access over site-to-site VPN with 2x RV110W
Hi all. I hope somebody can help me out as this is driving me crazy!
I have successfully created a site-to-site IPSEC VPN between two sites using two Cisco RV110W VPN firewalls. I have used the basic configuration defaults on each device and have configured the same pre-shared key at each site. The result is, the VPN is up and running and I can ping hosts at each site from the opposite site. In addition, I am able to establish VNC connections to devices and can even mount samba drives at each location, all be it slowly.
The only thing that I cannot access are web pages hosted at the remote site. I cannot figure this out, and have been through all the settings on the RV110s and cannot see anything obvious that needs to be turned on. Can somebody please help me out? I had hair yesterday.....today.....most of it is missing! :-/
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...