not able to remote vpn

[viveknathmangalat33]

hi , I am not able to remote vpn when I connect with my data card.

VPN login is success.

But when I trace to my LAN ip it takes the internet path.

attaching the routing table of my pc

thanks

vivk

[Jeff Van Houten]

What is the IP address space of the corporate network? What is the address space of the internal network? Are you using dhcp on the internal remote network? If so, is the internal gateway correctly configured within the dhcp scope? If so, why do you have a persistent default route?

Sent from Cisco Technical Support iPad App

[m1xed0s]

With Cisco VPN client, especially whe configured to tunnel all traffic, the persistent route is added once VPN is built.

However the difference from what normally should be and the screenshot: the persistent route is missing from the main routing table.

Something is wrong with your laptop.

[viveknathmangalat33]

not with my laptop, its seen with all the people irresprctive who uses this data card model.

But with my same laptop, if I use a cable internet, it works fine.

[Javier Portuguez]

Hello,

The WWAN cards are not supported.

http://www.cisco.com/en/US/docs/security/vpn_client/cisco_vpn_client/vpn_client5007/release/notes/vpnclient5007.html#wp45722

You could try updating the DNE driver though and check if there is any difference.

http://www.citrix.com/go/lp/dne.html

Otherwise, you may use AnyConnect.

HTH.

- Javier