I have a cisco 506e using PAT (split tunnelling) as an easy vpn remote client to a vpn 3000 concentrator. The concentrator downloads the IP and access list to the 506e. All connection out is good. I can't manage the Pat IP from my office. I can do this easily with a vpn 3002 hardware client but can't do so with this pix506e. I have setup the management tunnel but I get the error at the pix client 'no route to "PAT IP". The PAT IP isn't translating back to the inside interface?
I am trying to access the INSIDE interface via HTTPS. I have also tried the ssh and telnet without success. I have tried to access the outside interface with https too but without success. Any ideas would be much appreciated.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...