When starting PDM and going to configuration I receive an error that says
"PDM has encountered a firewall configuration command statement that PDM does not support. Configuration parsing has been stopped. PDM access is now limited to the Home and Monitoring views during the current session. To regain access to the rest of PDM use the command line interface window to fix the unsupported command statement and then refresh PDM with the modified firewall configuration
Access control list TX_To_HQ is applied to interface inside for outbound nat 0 and crypto map ToHQ for IPSec traffic selection. PDM does not support multiple uses of a given Access Control List"
That is the whole message. I use the access list as follows
access-list TX_to_HQ permite ip 172.16.12.0 255.255.255.0 172.31.1.0 255.255.255.0
and the other line this is referenced at is
crypto map ToHQ 20 match address TX_to_HQ
Also just a brief explanation of what I am trying to accomplish is just a vpn tunnel from Texas to NJ. In Texas I have a PIX501 going to a Sonicwall Pro 4060 in NJ.
Please let me know if you have any suggestions as to how to get around this error message. Thanks.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...