Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Pix 501 Tunnel not connecting

We switched internet service providers so i had to change the peer ip address and since than i cannot get the tunnel to connect any ideas?

4 REPLIES

Re: Pix 501 Tunnel not connecting

Check your config, check if the providr allows IPSEC traffic - also consider configuring NAT-T.

HTH>

New Member

Re: Pix 501 Tunnel not connecting

Thank you for your response. As i pointed out in the original post the configuration is about a year old and was working fine. As far ipsec traffic i will check and let you know.

New Member

Re: Pix 501 Tunnel not connecting

I spoke to the isp and they claim they are not blocking ipsec traffic

Re: Pix 501 Tunnel not connecting

Well just in case they - enable NAT-T on the tunnels

104
Views
0
Helpful
4
Replies