Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX 515E for VPN to remote Site

Hello,

Pix Version 7.0(1)

ASDM version 5.0(1)

I have a situation where we need to get paas-through VPN functionality going on our PIX 515E. I tried to set this on the pix using a VPN Wizard Site to site

which is enabled. I was unable to connect to the pix from the remote site. witch is log responded the pix negotiate is o.k and success

The problem is when I try to bring up the tunnel up from the remote site. I get dropped without failure.

where can I see the pix vpn log for error?

is there any manual for the VPN site to site solution using the wizard

Please help.

Thanks in advanced

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

Re: PIX 515E for VPN to remote Site

http://www.cisco.com/en/US/partner/products/hw/vpndevc/ps2030/products_configuration_example09186a00804acfea.shtml#asdm

the section "use adsm" (step 14) gives an example on how to configure lan-lan vpn via adsm

for log, go to section "verify"

1 REPLY
Gold

Re: PIX 515E for VPN to remote Site

http://www.cisco.com/en/US/partner/products/hw/vpndevc/ps2030/products_configuration_example09186a00804acfea.shtml#asdm

the section "use adsm" (step 14) gives an example on how to configure lan-lan vpn via adsm

for log, go to section "verify"

119
Views
0
Helpful
1
Replies
CreatePlease login to create content