Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX 515e Line Protocol Down on PIX 4FE interfaces

I am trying to upgrade a pair of aging 515s to 515e. Have moved the PIX 4FE cards to the 515e and all four of these ports remain in Line Protocol Down status when connected to a switch.

Have moved the cards back to the 515 and experience the same result.

Cisco has replaced the PIX 4FE cards. Tested today and got the same results.

Has anyone experienced this same issue? If so, what was the resolution?

Thanks

1 REPLY
Bronze

Re: PIX 515e Line Protocol Down on PIX 4FE interfaces

You can check that if the interface is set to "auto", make sure the device it is connected to is set to auto. Also try to hard code speed/duplex in your devices (ie. PIX and Switch).

270
Views
0
Helpful
1
Replies
CreatePlease to create content