I'm testing a modem to attach to a pix for a remote site install. The thing is that the modem works fine with a router (using the modem in out command under the aux port) but when connected to the pix I get no answer. Is there any config that needs to be applied to the PIX? I assume that the cabling setup to connect to the PIX console is the same as that to connect to the router. For ref the pix is a 506E.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...