Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

PIX OS 8.0 VPN, Static Nat, PAT configuration help

I have a PIX 515E, I need to do static NAT between my exchange server and the public IP which is seating in my inside network, I need a VPN to access the citrix server and I need a PAT with the outside interface of the PIX.

Below is my network layout, I tried to do the configuration but both the configurations are not working.

Kindly help suggest some sample configurations; I will be rating the suggestions.

5 REPLIES

Re: PIX OS 8.0 VPN, Static Nat, PAT configuration help

Regarding the STATIC outside >> inside natting have a look at this link:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a008067cf3b.shtml

This document is for mail, the CITRIX configuration is the same, just need to know the ports used.

For dynamic NAT/PAT you just need two lines:

nat (inside) 1

global (outside) 1 interface

Regards

Farrukh

Community Member

Re: PIX OS 8.0 VPN, Static Nat, PAT configuration help

Dear Farrukh

Thank you for your suggestions, can u please help us on the VPN also.

Regards

Harish Babu

Re: PIX OS 8.0 VPN, Static Nat, PAT configuration help

What kind of VPN are you looking for?

VPN Remote Access?

Regards

Farrukh

Community Member

Re: PIX OS 8.0 VPN, Static Nat, PAT configuration help

Remote access VPN to access my internal network.

Regards

Harish Babu

Re: PIX OS 8.0 VPN, Static Nat, PAT configuration help

Please have a look at these two documents, you can start from these and get back to the forum if you need any further assitance:

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a0080702999.shtml

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a008080f2d1.shtml

Please rate if helpful.

Regards

Farrukh

227
Views
0
Helpful
5
Replies
CreatePlease to create content