When I reboot my PC in the office our PIX stops transferring data and has to be reset. I usually telnet/ssh in and use reload and then everything works ok until my PC reboots. I know this is strange but I can repeat it over and over. My PC is set up as the tftp and syslog server. My PC IP is 192.168.16.120 if you look for it in the config. If the pix loses contact with either of these would it cause it to stop working? We are running PIX OS 6.3.5 with PDM 3.0.4. Config attached.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...