Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Problem accessing resources on DMZ and Inside

Hi Techies,

I have a pix515 doing remoteaccess VPN. People are successfully able to VPN into the box but are not able to access resources on DMZ or the inside. DMZ is directly connected to the PIX and inside is behind a CSS.

Could you people point me in right direction please.

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Problem accessing resources on DMZ and Inside

Abdul, is your issue resolved , have you tried suggested statements missing in your config.. let us know if still issues.

Regards

3 REPLIES

Re: Problem accessing resources on DMZ and Inside

Hi

you need couple of statements, should be fine after you add these .

nat (dmz) 0 access-list vpn-nonat

crypto isakmp nat-traversal 20

Let us know how works out.

Regards

Re: Problem accessing resources on DMZ and Inside

Abdul, is your issue resolved , have you tried suggested statements missing in your config.. let us know if still issues.

Regards

New Member

Re: Problem accessing resources on DMZ and Inside

Hi Jorge,

Thanks a lot for the reply. I was missing nat0 for dmz :-). It resolved the issue. Thanks again.

Abdul

116
Views
0
Helpful
3
Replies