After I configured it I tried to ping the other side but no luck. I looked into the access-lists and I can see the hitcount is incrementing. I did a debug crypto isakmp but no output for the new connection.
I'm out of ideas. Is it possible the PIX 6.3 doesnt like dyn and static crypto maps at same time?
Re: Problems configuring new LAN to LAN on PIX 6.3(5)
Be sure that you have configured all of the access lists necessary to complete your IPsec VPN configuration and that those access lists define the correct traffic. This list contains simple things to check when you suspect that an ACL is the cause of problems with your IPsec VPN.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...