Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PXE boot through FWSM

I am attempting to setup a windows deployment server to work through our FWSM. The workstation and DHCP servers are on different vlans on the outside interface of the FWSM. The WDS is a separate vlan on a different FWSM interface. The workstation is getting an IP and I verified that it is receiving option 66 and 67 using wireshark.

The client will get an IP address at boot, but I receive a TFTP open timeout error. I do not see any deny messages in the FWSM log viewer. I do have an ACL allowing TFTP to the WDS from any.

Does the WDS server need to be listed as a DHCP relay server in the FWSM config?

Any other possible solutions?

Thanks.

1 REPLY
New Member

Re: PXE boot through FWSM

I just realized this went into the wrong category, is there anyway to move it?

280
Views
0
Helpful
1
Replies
CreatePlease to create content