RA VPN for remote connection to Siemens Simatc S7 control system
has anyone experience with the following scenario?
A client connected to internet via DSL opens a tunnel to a production network where Siemens control system is used. On the client computer Simatic S7 and Simotion software is running. With this software a connect to the Siemens control system is needed. On the network where the Siemens control system is working, a ASA 5510 with SW 8.0.4 is installed. Until now I used a "normal" IPSec connection with Cisco VPN client to test this with no success. VPN connection works fine (RDP sessions are possible to machines inside the LAN) but Simatic S7 does not work from remote PC. The customer was using Linksys equipment before implementing the ASA as his internet gateway. With that equipment he could work with Simatic S7 through IPSec tunnel without any problems. Any ideas how to solve this task with the ASA?
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...