Redistributing Site to Site VPN into MPLS via OSPF?
I am working with an MPLS of about 5 sites. One of the sites is a co-lo where all the servers are located. There are two small offices connected via VPN to the colo site. These small offices now require connectivity to one of the offices that is connected via MPLS. For now I will connect them directly with a new site to site tunnel but ideally, I'd like to just re-distribute routes to the VPN sites.
I have tried to create a route-map matching the outside interface and issue:
redistribute static subnets route-map [word] to my OSPF configuration but that was unsuccessful.
Obviously, I'm not doing this correctly. Can someone please point out where I'm going wrong?
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...