Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

reg:asa5505

Dear sir,

i have three servers connected to switch from that switch to i connected to firewall through this firewall iwant to communicate this servers and already i configure the firewall plz guide me if any changes require.

iam attaching my config.

thanks&Regards

srini

1 REPLY

Re: reg:asa5505

Hi,

If the servers are all on Inside interface and they only need to access the Internet (servers initiate the traffic) then your config is fine.

By default, with no ACL assign, the ASA will allow the traffic from higher security interfaces (Inside) to lower security interfaces (Outside).

No NAT statement is required since "nat-control" command is not applied so all is good.

Please rate if this helped.

Regards,

Daniel

103
Views
0
Helpful
1
Replies
CreatePlease to create content