I am having a Site to Site VPN Tunnel .Phase 1 &2 are getting established however the issue is that at the remote peer end packets are showing as encrypted but not decrypted .The Access lists at both the end are mirror images .My requirement is that i want to run a packet capture with the capture command.However i want to know on which particular interface of my ASA shall i run the packet capture to see what is happening (i want to see the VPN Traffic however my confusion is as to what output will the Outside interface will show and what output will the Inside Interface will show).I am sensing a routing issue however in order to confirm and have an evidence , i think that "capture " command will show the desired output
Ankur, apply the capture to oustide interface where u terminate the ipsec tunnel.. work with one IP source from other end of tunnel for example, and it does not matter whether your inside host connects to other end host or the source hosts pings your inside host... you should see the output either way using outside interface..
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...