My question is very simple. At my office we have a Cisco 1811 router that is connected to our internal network. Dialer0 is connected to our ISP. We have a IPSEC tunnel running between one of the branch offices at a different location. Our 1811 is not a mainstream and we have a different firewall for the remote users. But the problem here is one of the workstations that's a MAC book would not connect to our firewall so i had to put him through 1811 to access our internal resources.
Since i am running an IPSEC tunnel on the dialer0 interface how do i configure Client access VPN and how do i map it to the dialer interface.
i have not had a chance yet to run the config. but i have a new problem. how can i integrate my windows active directory users to access remote access vpn rather than adding users manually. and also i want my domain controller (which is also my dhcp server) to lease out the ip addresses.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...