I have configured remote access vpn without using split tunnel.Everything is working fine.I can access all the inside network which is allowed in acl.
I am facing strange issue now. I have created a pool for remote access vpn with a range 192.168.5.8/29.I can access my internal subnets 10.10.0.0/16.
I have below acess-list for acl-in.
access-list acl-in extended permit ip object-group vpnclients 192.168.5.8 255.255.255.248
object-group network vpnclients
network-object host 10.110.100.26
network-object host 10.106.100.15
network-object host 10.10.10.6
network-object host 10.10.20.82
network-object host 10.110.100.48
network-object host 10.10.20.53
network-object host 10.10.20.54
network-object host 10.60.100.1
network-object host 10.10.10.75
network-object host 10.10.20.100
network-object host 10.10.130.136
network-object host 10.106.100.16
network-object host 10.106.100.9
network-object host 10.170.100.1
network-object host 10.170.100.2
network-object host 10.170.100.21
network-object host 10.101.100.20
network-object host 10.170.100.25
So whichever IPs i have called in vpnclient group is able to access via RA vpn.Issue is when i try to access internal network of 192.168.198.0/24, i am able to access it without adding in vpnclient group. Even for 192.168.197.0/24,192.168.197.0/24 the same. But for 10.10.0.0/16 we can access only after adding in vpnclient group. Any one has face this issue before. Is this because of same network i mean 192.168.0.0 something like that.There is no other staement in acl-in for 192.168.0.0
If i read correctly you made the RA vpn "without" split tunnel, correct? if that is the case, all of the traffic will traverse the vpn connection (tunnel all) , the access-list "acl-in" is of no use to it.
try converting it to use split tunnel, i am sure that way you can not access resources that are not mentioned in the list.
DocumentationCode download linksGoalRequirementLimitationsSupported ISR and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and UCS-E Blades:Step by Step ConfigurationConfigure one of the connectivity options to access the Cisco IMC from the n...
Firepower Threat Defense (NGFWv) on UCS E-series - Transparent Mode in HA
DocumentationCode download linksGoalRequirementLimitationsSupported ISR and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and UCS-E Blades:Step by Step ConfigurationCo...
I am currently unable to specify "crypto keyring" command when configuring VPN connection on my cisco 2901 router.
The following licenses have been activated on my router :