Remote Access VPN - Not able to access internal network

[Ejaz Ahmed]

Hi all

I have created remote access vpn in my ASA 5505. The tunnel is established but i am not able to access the internal network.

please help

Regards,

Ejaz                 

[jose.vieira525]

Hi Ejaz

Is this a new VPN tunnel that you have created?

If so remember that you still need to allow the traffic for that VPN DHCP pool in the inside interface so you can access the internal Network.

In case you allow just please paste the configuration here so I can have a look. Please make sure to remove sensitive information.

You can also use packet tracer to give a better idea where is dropping the traffic.

ciscoasa(config)#packet-tracer input outside icmp "source ip" "destination ip" detailed

Regards

Sent from Cisco Technical Support iPad App

[Ejaz Ahmed]

Hi Vieira,

Thank you for the response. Please check your private message.

Regards,

Ejaz

[jose.vieira525]

Don't have any personal messages

Sent from Cisco Technical Support iPad App