My goal is to allow my friend to use the Cisco VPN Client to connect to my home network. I have the ASA 5505.
I used the VPN Wizard to set things up, but I wasn't sure what to do in the NAT section so I left it blank. My friend is connecting from a local network of 192.168.2.0/24 and my local network (inside) is 192.168.1.0/24.
1. I was wondering if someone could look at the configuration I have so far, and let me know if I am on the right track and if I need to change anything.
2. When my friend uses the Cisco VPN Client, will he be using 'Enable Transparent Tunneling' & 'IPSec over UDP (NAT / PAT)'? Any other special options that he will need to set to connect?
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...