Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Remote Access VPN users unable to communicate with each other

Hi,

 

We have configured Remote Access VPN on Cisco IOS router. Users are able to access the inside resources but cant communicate to each other. Any suggestions on the issue?

 

Regards

Saif

Everyone's tags (1)
8 REPLIES

What type of RA VPN have you

What type of RA VPN have you set up? (AnyConnect, IPsec VPN, Easy VPN)

--

Please remember to select a correct answer and rate helpful posts

--

Please remember to rate and select a correct answer
Community Member

IPSec Remote Access VPN

IPSec Remote Access VPN

Hall of Fame Super Gold

Try adding this to the config

Try adding this to the config and see if the behavior changes

same-security-traffic permit intra-interface

and you might also try its companion command

same-security-traffic permit inter-interface

 

HTH

 

Rick

 

Community Member

Actually..these commands are

Actually..these commands are for ASA. We are discussing the IOS VPN.

Hall of Fame Super Gold

I obviously did not read the

I obviously did not read the original post carefully enough. Thank you for pointing out the difference in platform.

 

HTH

 

Rick

Community Member

You must insert the inside

You must insert the inside host in the access-list crypto and in the access-list nonat (nat(INSIDE) 0)

 

I have already mentioned this

I have already mentioned this in one of my posts, and NAT 0 is an ASA function we are talking IOS here (ie. routers)

--

Please remember to rate and select a correct answer

Have you excluded the VPN

Have you excluded the VPN traffic from being NATed when traffic is going between clients?

Please post a full sanitised configuration of the router so we can check it for configuration issues.

--

Please remember to select a correct answer and rate helpful posts

--

Please remember to rate and select a correct answer
155
Views
0
Helpful
8
Replies
CreatePlease to create content