Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Remote Access VPN

I'm trying to migrate some Remote Access VPNs for some power admins from a router to an ASA 5500. The profile I'm using is vpnclient. When I add the access-lists to reach the inside networks (10.200 and 10.25) All that shows up on the route print command is the 10.200 network. I can ping to any server or client but cannot ping any network device. I can't ping any device in the 10.25 subnet. Any help in this would be greatly appreciated. Below is the config.

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Remote Access VPN

Hi Mitch,

Ensure subnet 10.25.x.x pass thru nat (inside) 0 e.g. access-list 102

HTH

Mike

1 REPLY
New Member

Re: Remote Access VPN

Hi Mitch,

Ensure subnet 10.25.x.x pass thru nat (inside) 0 e.g. access-list 102

HTH

Mike

92
Views
0
Helpful
1
Replies