Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

remote vpn ipsec tunnel on a cisco 800 series

how can you configure remote vpn ipsec tunnel on a Cisco 800 router ?

12 REPLIES

remote vpn ipsec tunnel on a cisco 800 series

Hi,

If I understand correctly, you want to use the 800 router as a Hardware client?

If so, you can check this link:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080241a0d.shtml

The 800 router can accept remote IPsec connections (IPsec server), or act as an IPsec client to initiate a tunnel to an IPsec server. (This is what EzVPN is all about).

Federico.

New Member

remote vpn ipsec tunnel on a cisco 800 series

I want via laptop, ipad, desktop remote ipsec vpn to a remote router through Cisco AnyConnect and Cisco AnyConnect mobility

remote vpn ipsec tunnel on a cisco 800 series

New Member

remote vpn ipsec tunnel on a cisco 800 series

You can also configure without a web interface and allows you to configure a tunnel interface?

remote vpn ipsec tunnel on a cisco 800 series

New Member

remote vpn ipsec tunnel on a cisco 800 series

I have it configured but can not connect?

remote vpn ipsec tunnel on a cisco 800 series

You might want to check what I mentioned above.

If phase 1 is getting established:

sh cry isa sa

If there's nothing, verify that you have connectivity from the client to the IP of the Router you're trying to VPN to.

If phase 1 is established, verify phase 2:

sh cry ipsec sa

After that, the tunnel should established and traffic should pass. If not, we should see where the problem is.

Federico.

New Member

remote vpn ipsec tunnel on a cisco 800 series

this is the output of crypto isakmp sa and crypto ipsec sa

IPv4 Crypto ISAKMP SA
dst src state conn-id status

IPv6 Crypto ISAKMP SA

R1 # sh crypto ipsec sa

R1 #

remote vpn ipsec tunnel on a cisco 800 series

You're not getting any output.

Can you PING the router from the VPN client? (connectivity)?

If connectivity is fine, make sure that the output of those debugs are being sent to your output screen (telnet, console, etc.)

Federico.

New Member

remote vpn ipsec tunnel on a cisco 800 series

no it does not work

remote vpn ipsec tunnel on a cisco 800 series

Ok.

If you don't have connectivity from the client to the router we need to go back....

This is no VPN problem, since you're not even getting there...

Why is that you have no connectivity between the client and server has to be the first thing to resolve here.

Is it your client? Your ISP? Something in between?

Federico.

New Member

Re: remote vpn ipsec tunnel on a cisco 800 series

I'll just wait for the running-config just by sending

4733
Views
0
Helpful
12
Replies
CreatePlease to create content