You can have Cisco Router or Firewall or other 3rd party devices like Checkpoint devices as well on the other side.
That totally depends on your requirement.
You can also refer following document for configuration assistance:
Hope that helps.
I have looked cisco small business ISA550 and Cisco 861W Wireless router, are both would be compatible with ASA 5505 at main locaion and other device at remote site??
If I go for remote site also with 2nd ASA 5505, then selection of 2nd ASA will depend upon number of users at remote site going to aaccess VPN?? Please suggest me.
Thanks for your help!
Hey if you already have a another ASA 5505 with you nothing better than that. Apart from ASA as dinesh said you said use Any device which supports Ipsec configuration.
1. Does selection of ASA or Cisco router at remote site depends on how many users at remote site?? and is same applicable for main server site??
2. I have looked cisco small business ISA550 and Cisco 861W Wireless router, are both would be compatible with ASA 5505 at main locaion and other device at remote site??
3. I am planning to use two ASA 5505 and I already have one ASA 5505 when I am looking for 2nd I am getting different options depending upon number of users, please advice for this???
Nothing is hard and fast. Use what ever you have to build a site-to-site VPN.
If you have limited Inside host license/OS then just change it to unlimited inside host and you are good to go.
1-You should check what the show version states about the IPSec peers (Being the IPSec peers the devices that you will built a VPN tunnel against) not the amout of users.
2-Any devices that support IPSec will be compatible with the ASSA.
3-VPN between 2 ASAs 5505, that's cool. No problem regarding the amount of users (As far as I know the 10-50 user restriction does not take into consideration IPsec VPN users.)
I have decided to use Two ASA 5505.
for configuring ASA using ASDM: Please advise for this?? how I can get access thorugh ASDM??
how this "IP_Address of the interface of ASA that has been configured for ASDM Access", how can I configured ASA for ASDM access??
Already replied to your email.