Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

RV110W - VPN Site-To-Site with 2 Cisco

Hi all,

I have a problem with 2 routers RV110W CSB. I can not make a VPN site-to-site. I wanted to ask:

(1) - It can make a site-to-Site VPN between 2 routers RV110W CSB with firmware 1.2.0.9?

(2) - If the answer (1) is positive I do not understand where I make mistakes. We illustrate the configuration used:

Site (A):

- Telecom ADSL Static IP: 88.40.xxx.xxx

- NetGear DGN2200 ADSL2 + Router

   WAN: 88.40.xxx.xxx

   LAN: 192.168.0.1

   NAT: all redirected ports on 192.168.0.100

- Cisco Router RV100W CSB:

   WAN: 192.168.0.100 - 192.168.0.1 Gateway

   LAN: 192.168.1.1 - DHCP 192.168.1.100-200

   VPN: Choose VPN> VPN Basic Setup.

               Name field: <name>

               Pre-Shared Key: 1234567890 (ike policy : DES / MD5 / Group1 (768 bits))

               Remote Endpoint: IP Address

               Remote WAN (Internet) IP Address: 95.254.xxx.xxx

               Local WAN (Internet) IP Address: 192.168.0.100 (put on automatic)

            Secure Remote Connection

               Remote LAN (Local Network) IP Address: 192.168.2.0

               Remote LAN Subnet Mask: 255.255.255.0

               Local LAN (Local Network) IP Address: 192.168.1.0

               Local LAN (Local Network) Subnet Mask: 255.255.255.0

Site (B):

- Telecom ADSL Static IP: 95.254.xxx.xxx

- NetGear DGN2200 ADSL2 + Router

   WAN: 95.254.xxx.xxx

   LAN: 192.168.0.1

   NAT: all redirected ports on 192.168.0.102

- Cisco Router RV100W CSB:

   WAN: 192.168.0.102 - 192.168.0.1 Gateway

   LAN: 192.168.2.1 - DHCP 192.168.2.100-200

   VPN: Choose VPN> VPN Basic Setup.

               Name field: <name>

               Pre-Shared Key: 1234567890 (ike policy : DES / MD5 / Group1 (768 bits))

               Remote Endpoint: IP Address

               Remote WAN (Internet) IP Address: 88.40.xxx.xxx

               Local WAN (Internet) IP Address: 192.168.0.102 (put it on automatic)

            Secure Remote Connection

               Remote LAN (Local Network) IP Address: 192.168.1.0

               Remote LAN Subnet Mask: 255.255.255.0

               Local LAN (Local Network) IP Address: 192.168.2.0

               Local LAN (Local Network) Subnet Mask: 255.255.255.0

IPSec Connection Status: "IPSec SA Not Established"

I'm waiting, and sorry for the english but I'm Italian.

  • VPN
Everyone's tags (3)
1387
Views
0
Helpful
0
Replies