Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Safenet Softremote VPN Client 10.8.3 with Pix 6.3(5)

Dear All,

I am using the VPN software in object, for the first time.

I have just configured the vpn tunnel and the phase I And Phase II are ok.

So the tunnel go up, but the SafenetVPN client do not create the virtual adapter!!!!

I think that the problem is due by the pix config, the Cisco command reference guide 6.3 tells about vpngroup command:


"Supports Cisco VPN Client Version 3.x (Cisco Unified VPN Client Framework) and Easy VPN Remote
devices"

Infact to exchange the isakmp key I have used :

isakmp key ******** address 0.0.0.0 netmask 0.0.0.0 no-xauth

instead of the vpdngroup command.

My question is, there is a way to configure the ip local pool and the wins and dns setting for the other VPN Clients?

Best regards,

Igor.

881
Views
0
Helpful
0
Replies
CreatePlease to create content