SBL and Windows group policy user configuration preference
We would like to have user connects to VPN via SBL and then login to the AD domain. Ideally, the group policy user configuration preference, such as drive mapping, should be applied after successful AD login. However, we are running into issue where the preferences are not being applied. It appears the AnyConnect VPN tunnel is not completely established after the user login to AD; and hence the GPO preference was not able to apply. It takes about 1 min.after the user's AD login before the VPN tunnel is completely established.
Just want to find out if anyone is able to get SBL and AD GPO preference working successfully.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...