Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Site to site Ipsec not working at all

Hi,

I have this situation:

I configure a basic Site to Site IPsec VPN in my lab (it worked), and after that I moved one of the ASAs to a remote end. Now the two ASAs are communicating trough a Layer 3 MPLS link (not important, I think), but I can´t do the tunnel works.

I have connectivity between the firewalls, even between pcs connected to the Firewalls with static NAT.

No isakmp associations, or ipsec as.

The only message I have from the remote ASA  is this:

Ignoring msg to mark SA with specified coordinates < DRVPN, 10> dead

Any help will be appreciated.

Regards

.

2 REPLIES

Site to site Ipsec not working at all

Post your config for review.

New Member

Site to site Ipsec not working at all

Thanks Andrew, but I figured it out what was happening: I configured a dynamic NAT in the remote end before the MPLS connection were ready. Without that, all is working. Now, I´m only need and access list in order to separate the traffics.

Regards, and thanks again

469
Views
0
Helpful
2
Replies
CreatePlease login to create content