Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Site to site question

Is there a way to initiate the VPN tunnel from within the pix?

1 REPLY
Cisco Employee

Re: Site to site question

Hello,

There is, you would need pix code 6.3 for this.

The new code as a command management access for these things. In our case the command will be

management access inside. (please check the syntax)

This command will enable the PIX inside interface to talk to the tunnel clients/networks. for example if you would like to access PDM through VPN tunnel you will be after adding this command.

After enabling this command you can initiate the tunnel from within pix by ping destination ip.

eg. ping inside 192.168.3.10. Now the ping command will take the inside ip as SOURCE in the ICMP packet. Make sure you have pix inside ip/network in the crypto acl.

Vikas

127
Views
0
Helpful
1
Replies
CreatePlease to create content