Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Site to Site VPN NAT traffic to one IP

I am looking to NAT all of my traffic going to the VPN site to site tunnel and only use one IP.  Has anyone done this?  This is the configuration I am using:

access-list my_accesslist extended permit ip 192.168.1.0 255.255.255.0 object-group remote_address

global (outside) 2 192.168.100.8

nat (inside) 2 access-list my_accesslist

2 REPLIES

Site to Site VPN NAT traffic to one IP

You can do it just make sure other site is not going to initiate traffic.

Here is the example for NAT you can modify yours according to that.

you will have to use policy-nat configuration mentioned above by you wont work.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00808c9950.shtml

Thanks

Ajay

New Member

Site to Site VPN NAT traffic to one IP

Are you saying the configuration I am using will not work?  Unfortunately I am not able to test until tomorrow.

319
Views
5
Helpful
2
Replies
CreatePlease to create content