I'm very new to cisco equipment and was hoping someone could help me with this issue I have. I am trying to set up a VPN from a cisco 837 router that I have to another company, which I think is using a PIX. After some tweaking I managed to set the same VPN up from another site we have, which uses a 3000 concentator. However after using cisco SDM and using as many commands as I know how I cannot get the VPN tunnel to come up. Essentailly I want <server1> and <server2> (as shown in the attached show run) to be able to access 192.168.0.100 that is off of my 837 router. Any help would be very gratefully received.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...