I need to setup a IPSec VPN tunnel, the far end site ASA is behind Cisco 7200 series Router and is acting as a NAT device for Cisco ASA. The config is fine on both the ends but we are still not able to establish a VPN tunnel, i don't see anything in Debug on my side.
Is it possibe to have Site2Site VPN tunnel behind a NAT device.
The Peer IP which is provided to me is the Router (cisco 7200 Series) outside IP which is NAT to a private IP on the outside interface of ASA.
so you are not able to establish vpn tunnel right. Can you see if you get any debugs at all on any of the ASAs? try initiating from your ASA and see if you see some debugs atleast on where its failing.
deb cry isa sa 127 should do. term mon if you using a monitor session to show debugs.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...