I am trying to setup a site to site vpn on two 515e pix running version 7. Both pix have three interfaces. I am trying to configure the failover using osfp on both pix. One tunnel will go through the internet and the other one will go through a dsl line.
I think this is a new feature in pix version 7 and i am worried about going to the customer site and not sure what to do.Does someone have a template that i can use?
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...