Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Split tunnel / Local LAN access

What troubleshooting steps can we performed if Anyconnect Client is unable to access the Local LAN after establishing a tunnel to the ASA. Pointers to any troubleshooting URLS much appreciated.

New Member

Re: Split tunnel / Local LAN access

Any Connect version 2.1

Re: Split tunnel / Local LAN access

check ur split tunneling ACL

check the netbios server and dns if u are using

also make sure that have created NAT exmption also called NAT 0

with the comman

nat (inside) 0 access-list 100

where access-list 100

is an access-list matching traffic from ur LAN to the anyconnect van client pool

for example if u lan

and ur pool with

make it as follow

access-list 100 permit ip

and apply it to the nat examption (nat 0 ) as i have done above

good luck

please, if helpful Rate