Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Split Tunnel/Route issue

Hi Guys,

Running into a small problem with RA IPsec VPN. I have configured a simple VPN on a Cisco 1841 12.4T, users can connect in no problem. The split tunnel ACL has been referenced and works well. Once the user has connected to the VPN using the VPN client software I can see only the routes specified in the "Secure Routes" table are eligible for encryption.

The problem is that whenever a user connects to the VPN not only does the split tunnel route get added to the hosts routing table (i.e 10.44.1.0/24) but also a classful 10.0.0.0/8 is created and pointed down the VPN. This breaks corporate network access as most of office is on a 10.x.x.x range address.

The host in question is Windows 7 + Cisco VPN client 5.0.07.0410. Anyone else experienced similar issues or know of a resolution?

Regards,

Matt

263
Views
0
Helpful
0
Replies
CreatePlease to create content