Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

spoke router vpn to Pix hub no split tunnel no nem solutions?

Is there way for an IOS remote vpn router to vpn to a central pix firewall and ensure that all internet traffic generated by the remote goes over the tunnel to the pix and is filtered by the pix going out ? Centralized security policy and filters are built around the host pix hence the requirement. Short of running EZvpn network extension mode I cannot find a solution on cco nor any configuration snips.

If you have this running please post a config snippet.

4 REPLIES
Gold

Re: spoke router vpn to Pix hub no split tunnel no nem solutions

New Member

Re: spoke router vpn to Pix hub no split tunnel no nem solutions

That is a sample doc for soft clients connecting to Pix asa 7.0 not what I am looking for.

New Member

Re: spoke router vpn to Pix hub no split tunnel no nem solutions

You will have to connect the PIX to the internet over two interfaces.One for terminating the IPSec and the other for internet access.Traffic into and out of the PIX firewall cannot be on the same interface.Thanks..

Gold

Re: spoke router vpn to Pix hub no split tunnel no nem solutions

raju,

no offence but this restriction has be removed with v7. have a look at the link i posted above.

119
Views
0
Helpful
4
Replies