Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

SSC-400 / SSC-600 / IPsec SPA resets during SSO

Hello,

I want to know if there is any way we can overcome the restrictions on these cards, resulting in reload when an SSO happens on a Catalyst 6500 switch.

Restrictions:

>VSPA state information is not maintained between the active and standby supervisor engine during normal operation. During a supervisor engine switchover in an SSO environment, the VSPA will reboot.

>The Cisco 7600 SSC-400 is not Route Processor Redundancy Plus (RPR+) or Stateful Switchover (SSO) aware. As a result, the Cisco 7600 SSC-400 will reset if RPR+ or SSO is configured.

http://www.cisco.com/en/US/docs/interfaces_modules/shared_port_adapters/configuration/7600series/76ovwvpn.html#wp1108766

http://www.cisco.com/en/US/docs/interfaces_modules/services_modules/vspa/configuration/guide/ivmovw.html#wp1051863

Regards,

Akhtar

Everyone's tags (6)
366
Views
0
Helpful
0
Replies
CreatePlease to create content