I am trying to configure Anyconnect SSL VPN on my ASA5505 at home. I have the connection up and able to come in and go back out my Outside interface and browse the web, but not able to access any internal resources. I am not very familiar with the ASA's configuration. Below is how my network is setup and the ASA config. Any advice?
---- (Home VLAN - 192.168.10.0/24)
(AnyConnect - 192.168.205.200/24) ---- Internet ---- (ASA)-----
I have EIGRP running on the ASA and Lab Router. I can see the Anyconnect client's IP address of 192.168.205.200 in the Lab router routing table, but not able to ping it from anywhere and the Anyconnect client can not reach any devices in the 10.1.5.0 network.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...