No, the anyconnect client works by installing a virtual interface on the remote pc. The VPN address pool should be defined as something other than 192.168.x.y. If you do so and set routing on your main network to point to the Asa for the address pool, you should be fine.
As you can see (and something i forgot to mention) ip local pool assigns different network address to clients. The problem is when my pc or iphone access a guest network that has network address same as defined on protected subnets of remote network, i cannot access local resourses on guest network. Guest local network has 192.168.1.0 for example. I connect successfully to ssl vpn.. i can access remote network that has 192.168.1.0 protected subnet but i can't access other hosts (printers,pcs) on local guest network. If i remove 192.168.1.0 from protected subnets i can access local resourses on guest network but not the remote network
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...