This line should convert any IP address arriving at the (dynamically addressed) dialer 1 interface with a TCP Port of 8080 to address 192.168.100.10 with a TCP Port of 80 but it does not work.
Furthermore I cannot access the web camera using a local address on a VPN Client using port 80 but if I remove the line from the configuration then it works from the VPN Client but obviously not from the Internet.
Is this a limitation of running a VPN Server on a router that is assigned an ip address dynamically.
Does anyone have any idea on how to run a VPN Server and static NAT at the same time?
On the static PAT, you need a route-map configured similar to how you have it for the PAT you have. For the VPN, what will happen is that the traffic will get statically PAT'd back to 8080, based on the line that you have.
Also, I am assuming that 126.96.36.199 is pointing to the router as its default gateway.
PS. If you found this post helpful, please rate it.
I've looked at using a route map and come up with this, does it look correct? I haven't tried it yet because the last attempt at a route-map locked me out of the router from the internet and I forgort to do a scheduled reload before I configured it.
The ISP address always starts with 79.x.x.x and the camera is on 192.168.100.10
ip nat inside source route-map TEST interface dialer 1
route-map TEST permit 10
match ip address 113
set ip next-hop 192.168.100.10
access-list 113 permit tcp 188.8.131.52 0.255.255.255 -eq 80 any
Will I also have to configure a routemap for UDP Port 4500 so that the VPN Client works?
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...